Steema Central

I have a problem using visual studio 2010 (32bit) where all the toolbox controls are greyed out.
The project is a legacy one built under framework 3.5 and dependancies mean it cant be changed.
Its also a team project.

My colleagues are all mostly on 64bit VS2010 and a mix of windows 7 and XP. So a workaround cannot impact them too much.

How do I rectify this problem ?

I noticed a partial post that talked about installing the .net 2010 fro 2008 as a solution .... are these the same as the ones I have installed or is this an older version of Teechart ?? that would be bad ..

Hi Snarkle,

I have a problem using visual studio 2010 (32bit) where all the toolbox controls are greyed out.
The project is a legacy one built under framework 3.5 and dependancies mean it cant be changed.
Its also a team project.

You should target Framework 4.0 for them to be available.

I noticed a partial post that talked about installing the .net 2010 fro 2008 as a solution .... are these the same as the ones I have installed or is this an older version of Teechart ?? that would be bad ..

No, with each TeeChart 2010 .NET release we provide VS2003, VS2005, VS2008 and VS2010 installers. You should just install VS2008 binary installer an add TeeChart.dll to the toolbox manually as describe here.