Steema Central

Posted: **Wed Dec 21, 2011 2:21 pm**

Hello,

I noticed a pixel error in the way the bar pen is drawn. The following picture shows the case where I have two bars, one white and one gray. The white is behind the gray one, and it has a 1px black pen, whereas the gray doesn't have a pen.

: bar pen pixel issue.png (7.5 KiB) Viewed 4172 times

As you can see, the line is drawn inside the bar on the left-hand side, and outside on the right. It is only a single pixel that is affected by this, if you set the pen width to 10 px, there will still be a single pixle error on the right hand side.

Is there a way to specify that the pen should be drawn outside the bar?

Posted: **Thu Dec 22, 2011 11:32 am**

Hello

I think a solution for you would be set the Pen color of your Series Gray as same color of Brush of your Series Gray, you can do something as next:

Code: Select all

        Steema.TeeChart.Silverlight.Styles.Bar bar1,bar2;
        private void InitializeChart()
        {
            tChart1.Aspect.View3D = false;
            bar1 = new Steema.TeeChart.Silverlight.Styles.Bar(tChart1.Chart);
            bar2 = new Steema.TeeChart.Silverlight.Styles.Bar(tChart1.Chart);
            bar1.FillSampleValues();
            bar2.FillSampleValues();
            bar1.Color = Colors.White;
            bar2.Color = Colors.LightGray;
            bar1.Pen.Color = Colors.Black;
            bar2.Pen.Color = Colors.LightGray;
            bar1.MultiBar = Steema.TeeChart.Silverlight.Styles.MultiBars.None;

        }

Can you tell us if previous code works as you want?

Thanks,

Posted: **Thu Dec 22, 2011 11:52 am**

Thanks, I didn't think of that. I'd still argue that the right line is one pixel too far to the right, but at least now it is not noticable

Steema Central

One pixel drawing issue with bar pen

One pixel drawing issue with bar pen

Re: One pixel drawing issue with bar pen

Re: One pixel drawing issue with bar pen