Volume Series - Sides fall off (not visible)
Posted: Sat Sep 30, 2006 10:09 am
Hi,
When you use a Volume Series on a TeeChart with default settings, the sides fall off (the bar with the lowest and highest x value are not visible).
You can simply see this by opening the Feature Demo and opening the Volume demo. There's no bar for the highest and lowest x value, although the values do exist.
You can edit the chart and introduce an offset for the bottom axis (minimum and maximum), which will make them visible. Or you can increase the volume line width, which will make part of it visible since the bars grow wider.
Is this meant to be this way? Shouldn't the autoscale algorithm take this into account?
For example, if you change the series type to that of a Points Series (through the chart editor), the autoscale algorithm takes into account that the points have a certain width, and you don't see this problem.
Regards
When you use a Volume Series on a TeeChart with default settings, the sides fall off (the bar with the lowest and highest x value are not visible).
You can simply see this by opening the Feature Demo and opening the Volume demo. There's no bar for the highest and lowest x value, although the values do exist.
You can edit the chart and introduce an offset for the bottom axis (minimum and maximum), which will make them visible. Or you can increase the volume line width, which will make part of it visible since the bars grow wider.
Is this meant to be this way? Shouldn't the autoscale algorithm take this into account?
For example, if you change the series type to that of a Points Series (through the chart editor), the autoscale algorithm takes into account that the points have a certain width, and you don't see this problem.
Regards