Page 1 of 1
CONTOUR series problem
Posted: Fri Jan 11, 2008 3:35 am
by 9637403
CONTOUR Series Levels Tab of the editor. Automatic and Number aren't working properly. Only when automatic is checked can the Number be changed Also if the number of levels is set at 20 then the Level: --> Level box cant be set higher than 10. Also what does the text box to the right of the Level box indicate and what is it used for?
Posted: Fri Jan 11, 2008 9:43 am
by narcis
Hi Adrian,
CONTOUR Series Levels Tab of the editor. Automatic and Number aren't working properly. Only when automatic is checked can the Number be changed Also if the number of levels is set at 20 then the Level: --> Level box cant be set higher than 10.
I've added this issue (Also what does the text box to the right of the Level box indicate and what is it used for?) to our defect list to be enhanced for next releases.
Also what does the text box to the right of the Level box indicate and what is it used for?
Displays ContourLevel.UpToValue property value which sets range value for ContourLevel.
Posted: Thu Jan 24, 2008 10:43 pm
by 13047134
Tested with V 3.2.2945.19736, not fixed
Posted: Fri Jan 25, 2008 12:46 pm
by narcis
Hi Adrian,
This defect was assigned a bug-tracking number before the release of version 3.2.2945.19736. Therefore, if the defect had been fixed for this release then mention of it together with its reference number would have appeared in the release notes. As you can see in the release notes here:
http://www.steema.com/files/public/teec ... elease.txt
No mention of the defect being resolved is made. As a general rule of thumb, and to save you time, one can consider defects which are not stated as resolved in the release notes as still being a problematic issue. In this sense, there is little need for you to check that they are still there.