DepthTop axis moves opposite direction from label ZPosition

SteveP · Post by **SteveP** » Thu May 11, 2006 6:25 pm

The axis line for the DepthTop moves up vertically off the top edge of the chart as its ZPosition (Z %) increases from 0 while the labels move correctly downwards. This can be seen using the chart editor and a FastLine series.

TChart 7.06 delphi 7

Steve

Narcís · Post by **Narcís** » Fri May 12, 2006 8:19 am

Hi Steve,

I may not understand what are you exactly reporting but I can not reproduce this issue here. Could you please send us a screen-shot or let us know the exact setps we should follow so that we can figure out which the problem and reproduce it here?

Thanks in advance.

SteveP · Post by **SteveP** » Fri May 12, 2006 2:50 pm

Add a line series to a chart (a 3D line series is ok to use).

Go to : chart > axis and select the Depth Top axis.

Go to : chart > axis > scales and check Visible box to show the Depth Top axis. "Series1" label will appear at the top left of the chart

goto : chart > axis > position and increase the Z% value from 0 to a few percent. As you do, the depth top axis label "Series1" will move down (as it should) but the axis line itself moves up (the axis line should move down also).

Steve

Narcís · Post by **Narcís** » Fri May 12, 2006 2:57 pm

Hi Steve,

Thanks for the information. I've been able to reproduce the issue here and added it to our defect list (TV52011403) to be fixed for future releases.