Multiple axes and zooming

fabnav · Post by **fabnav** » Mon May 14, 2007 6:50 pm

Hi,

Is there any way to control how charts with multiple axes zoom? I am using the left axis and three custom vertical axes. When I zoom with my mouse, only the vertical scale of the left axis is adjusted, even if I zoom in on an area controlled by one of the custom axes. The behavior is not very useful.

Regards,

Bill

Narcís · Post by **Narcís** » Tue May 15, 2007 9:28 am

Hi Bill,

Zooming is not supported on custom axes. Please read this FAQ item on how to zoom custom axes.

Thanks in advance.

glazer · Post by **glazer** » Sun Dec 02, 2007 11:22 am

Zooming is not supported on custom axes. Please read this FAQ item on how to zoom custom axes.

I tried to go to this FAQ but it is not there.
Mike

xxxxxx · Post by **xxxxxx** » Sun Dec 02, 2007 6:34 pm

Look at http://www.steema.com/support/faq/NewVC ... ES.htm#Q15 "Custom axes do not zoom. Any solutions?" as an initial step.

xxxxxx · Post by **xxxxxx** » Sun Dec 02, 2007 6:50 pm

And don't forget to replace "IZoom" by "Zoom"

amir6821 · Post by **amir6821** » Mon Dec 03, 2007 9:58 am

Hi Bill

I have done it, left axes and four custom axes, and user can zoom in custom axes, give me your email address so i send you the source code.

Ali.

Multiple axes and zooming

Multiple axes and zooming

Zooming on multiple axesd

Zoom in Custom Axes