Thickness of OHLC Bars

stratadat · Post by **stratadat** » Thu May 01, 2008 3:06 pm

Hello.

Is there any way to control the thickness of the OHLC bars in TeeCharts for .Net? They seem to always be one point wide. I would like to be able thicken the bars if fewer bars are displayed on a chart and thin the bars if the bars are more densely packed on the chart.

Thanks,

Richard.

Narcís · Post by **Narcís** » Mon May 05, 2008 7:19 am

Hi Richard,

Yes, you can use this:

Code: Select all

			candle1.Pen.Width = 3;
			candle1.HighLowPen.Width = 3;

stratadat · Post by **stratadat** » Tue May 06, 2008 12:07 pm

Thank you very much Narcis.

Does this apply to both OHLC bars and Candlesticks?

Regards,

Richard.

Narcís · Post by **Narcís** » Tue May 06, 2008 1:04 pm

Hi Richard,

Yes, the first instruction is for setting the pen of the bar that defines the open and close values while the second is for setting the pen of the line that marks high and low vales.

stratadat · Post by **stratadat** » Tue May 06, 2008 1:50 pm

Perfect. Thanks again,

Richard.