Names of QR Units changed?

[GTI]

Hello,

After installing Teechart and recompile the teechar packages in have to recompile my QRDESING packages (because I activate the Teechart directive in QRDESIGN.INC I needed to recompile them)

For recompiole the QRD Packages I needed tochange the uses of the units like:

{$IFDEF Teechart}
QrTee,TeeProcs, TeEngine,Chart,Series,TeeShape,ArrowCha,VGanttCh,BubbleCh,
{$ENDIF}

for:

{$IFDEF Teechart}
QrTee,VCLTee.TeeProcs, VCLTee.TeEngine,VCLTee.Chart,VCLTee.Series,VCLTee.TeeShape,VCLTee.ArrowCha,VCLTee.GanttCh,VCLTee.BubbleCh,
{$ENDIF}

In units like QRDCtrls and others, this is just an example. How you can see above, I had to aggregate the VCLTee. prefix, because Chart.dcu wasn't in my Teechart installation. only was VCLTee.Chart.dcu, so I changed it and with the other units I did the same. With this change QRD packages compiles. But, Is this correct?

Thanks.

[Yeray]

Hi,

XE2 introduced the prefixes forcing us to use them. But you can add VCLTee to the "unit scope names" in your project without having to edit every unit using TeeChart:
http://www.teechart.net/support/viewtop ... 277#p61277

[GTI]

Thanks, I did it!